SSD500-SFC-MKⅡ
Trimming Automatic Press Machine

By synchronizing the servo motor on the press side with the servo motor on the feeder side, high-precision punching can be performed while feeding the products on the multi-layout sheet at any specified pitch. The digital servo control by the AC servo motor and the touch panel/manual pulse handle operation have the following features in terms of operation and control.

Press Section
The underdrive system with a high-rigidity 4-pillar structure ensures a more stable mechanism. The top dead center, intermediate point, bottom dead center, and cutting depth can be easily set to any position in 0.1/0.01mm increments using the manual pulse handle. A positioning pin (air cylinder driven) is installed in the die, and the press stops once at this pin exit position (intermediate point). The pin is securely inserted before the punching operation, ensuring no floating of the product workpiece and enabling stable punching.

The press allows for two consecutive cutting settings. The cutting speed can be selected from high-speed or low-speed, enabling a variety of continuous cutting settings.

Feeder Section
The pitch can be set arbitrarily. If the data between pitches is the same, the repeat function simplifies input. The positioning pin insertion/removal settings and fine adjustments while checking the sensor position can also be made. Test runs can be performed in data creation mode, allowing for verification of the created data. Additionally, point corrections are possible.